by Mike Folta | Aug 27, 2026 | Sandblasting & Painting
Match the coating chemistry to what the containment actually holds, not to what’s cheapest or fastest to install. Novolac epoxy handles continuous immersion in fuels, oils, and most acids. Vinyl ester takes over when oxidizers or chlorinated solvents enter the...
by Mike Folta | Aug 26, 2026 | Sandblasting & Painting
Industrial sandblasting typically runs $2 to $9 per square foot, with full project totals for mid-size assets landing between $2,000 and $18,000 depending on scale, access, and coatings involved. Heavier jobs with hazardous coatings, tight geometry, or strict...
by Mike Folta | Aug 25, 2026 | Sandblasting & Painting
OSHA’s floor marking rule is short and often misread: 29 CFR 1910.176(a) requires that “permanent aisles and passageways” in workplaces using mechanical handling equipment be “appropriately marked.” That’s it. The standard is performance-based. It doesn’t name a...
by Mike Folta | Aug 24, 2026 | Sandblasting & Painting
A concrete surface profile (CSP) is the quantified texture of prepared concrete, measured on a scale of 1 to 10, and it determines whether a coating or overlay actually bonds or peels off within a year. Get the CSP wrong and you get delamination, blistering, or a...
by Mike Folta | Aug 23, 2026 | Sandblasting & Painting
For permanent forklift aisles, use two-pack epoxy over a properly shot-blasted or diamond-ground floor. For leased space or pedestrian zones you’ll reconfigure within a year or two, use heavy-duty floor tape. For outdoor yards and loading docks, thermoplastic holds up...